How to Install the Tobii Dynavox T10 Handle

The handle for the Tobii Dynavox T10 is easy to install. All you need to do is remove the screws from the back of your T10, position the handle, and then attach it using the two Phillips screws provided in the Handle Kit.

The Tobii Dynavox T10 Handle Kit includes the following:

• Tobii Dynavox T10 handle
• Hex-head Allen wrench
• Two Phillips screws

Remove the Screws from the Back of the T10

Using the hex-head Allen wrench included in the handle kit, remove the two screws from the back of your T10.

Position the Handle

Position the handle on the back of your T10 as shown in the illustration below. Line up the screw holes in the device with the screw holes in the handle.

Attach the Handle

Using a Phillips screwdriver (not included in the handle kit), screw the two provided Phillips screws through the holes in the handle and into the device.

Note: The specifications of the Phillips screws are: 8-32 x 1/2" flat-head machine screw, black oxide with NyLoc (DynaVox part # 140381).